Factory inspection process for linear module slide table:

1. Smoothness test after assembly;

2. Is the fixed orientation and spacing of the body reasonable;

3. Whether the fixed hole size of the servo motor matches;

4. Is the fixed hole size specification correct for the linear sliding table module;

5. Whether the assembly position of the photoelectric switch is correct and there is no interference;

6. Are the specifications of the coupling, installation shaft hole position, and hole diameter correct;

7. The screws in each part are securely fastened and properly marked;

8. Inject lubricating oil into the transmission mechanism (screw, guide rail, etc.);

9. Confirm again whether the order parameters and production machine parameters meet the requirements;

10. Appearance inspection shows no oil stains, aluminum residue, or scars;

When completing the assembly and inspection process of the linear module slide table, precision testing of the slide table module is also required:

Condition: In a dust-free operating room and on a granite platform:

1. Repetitive positioning accuracy;

2. Walking parallelism;

3. Walking at an equal height;

4. Noise level detection;

5. Other inspections of linear sliding table module;

Confirmation of other accessory testing:

1. Coupling;

2. Number of photoelectric switches;

3. Cable protection chain;

4. Whether to connect the board;

5. Whether it is a synchronous belt/synchronous wheel, etc;

6. Check other screws and accessories of the linear module.